2.10
~~~~

        - Fix bug where desynchro appears after a long period and after unplug/plug a speaker
        - Remove the glitch when enabling or disabling the audio effects
        - Implementation of BassBoost Version 3
        - Normalization of the wide stereo effect
        - Fix bug with SAMSUNG MP3 Player YP-T9
        - Fix bug with Sony Ericsson phones with Philips BT1.2 chip
        - Fix bug when de-activating ramp-up while the ramp-up is in progress, the volume was at max value
        - Fix bug when a blank happends in the music, the ramp-up was re-activated immediately


2.00
~~~~
	- Increase supported output power, and avoid losing one bit of precision on data signal.
	- Shorten long press for mute to 500ms, increase long press for reset to 3 seconds.
	- Balance can now be finely adjusted using the front panel buttons. The step is now 0.5dB instead of 2dB in earlier versions.
	- Software update via Object Push.
	- Erase least recently used device when 10 devices are already paired.
	- Support ConfigTool notifications. When changing balance, volume or device list on PSS, connected ConfigTool gets updated.
	- Synchronize blinking of LEDs on all connected speakers.
	- High volume ramp-up. When volume is greater than some limit, volume is set to the limit when the playback is started, and ramps up to the current volume. This also applies when making a big volume adjustment (with config tool for example).
	- Multiple speakers update.
	- Audio mixer support. Allows to configure separate volume levels for line-in/left, line-in/right and Bluetooth source.
	- Configurable audio delay. Audio delay can now be adjusted from 50ms to 1s. Default delay is now 150ms.
	- Full class of device is displayed in ConfigTool's device list.
	- Fix issue when switching to degraded mode: audio was not downmixed to mono.
	- Prevent 'Config' button to work while in 'update' state.
	- Faster detection of speaker being unplugged during streaming.
	- Improve behavior with Samsung phones when switching from degraded to nromal mode while streaming.
	- Force resynchronization after a long time with no synchronization, to avoid being desynchronized due to clock drift.
	- Fix connection problems with Samsing Z400 and E900 phones.
	- Fix rendering of 16kHz and 32kHz audio.
	- Fix playback speed, which was slightly too low.
	- Shutdown amplifier when not in use, to spare power and avoid generating noise.
	- Changes to delay and channel inversion are now applied immediatly, even during streaming.
	- Improve precision of line-in detection filter.
	- LED blinks between red and blue during update.
	- Fix bug when resetting one speaker while it is being updated: it could prevent the other one from restarting.
	- When pairing with a custom PIN code, use that PIN code for the whole pairing session. It was previously used for one pairing attempt only.
	- Fix a few seldom crashes in line-in and Bluetooth.
	- Fix some synchronization issues in line-in and Bluetooth.